Helpline No. UK / Northern Ireland 0870 7323023 • Rep. Ireland 1800 481005
Web support: www.omegawolf.com/powercraft
Model number: PS-750L
09
Safety instructions
persons to use the machine who are not familiar with it or who have
not read these instructions. Electric tools are dangerous, if they are used
by inexperienced persons.
(e)
Maintain the machine with care. Please check whether the movable
parts are perfectly operational and do not jam, whether parts have
broken or have been damaged in such a way that the function of the
machine is impaired. Have damaged parts repaired prior to using the
machine. Many accidents are caused by electric tools which are poorly
maintained.
(f)
Keep all cutting tools sharp and clean.
(g)
Use the electric tool, the accessories, the insert tools, etc according to
these instructions, and in the way described for this special type of
apparatus. In the process, take the working conditions and the work to
be carried out into consideration. Only use this belt sander for the
purpose for which it is intended.
(h)
Use clamps or vice to hold work. It is safer then using your hands and
frees both hands to operate the tool.
5) Servicing
(a)
Have your machine repaired by qualified expert staff using original
spare parts only.
(b)
Caution! The use of accessories or add-on devices other than those
recommended in these instructions may mean a risk of injury. Use
original spare parts only.
Additional safety instructions
Before using the appliance:
•
Check the following points:
• The voltage of the motor (230 V) should correspond to the mains voltage.
• The feeder cable and plug should be in good condition without any loose
bits or damage.
• The saw blade should not show any cracks or fractures and should not
have lost any teeth. Otherwise, the saw blade should be replaced
immediately.
• There should be enough room underneath the workpiece to prevent the
saw blade from coming in contact with the floor or worktable as it moves
up and down.
•
The teeth should always point upward.
•
Always wear protective goggles when using the appliance.
Helpline No. UK / Northern Ireland 0870 7323023 • Rep. Ireland 1800 481005
Web support: www.omegawolf.com/powercraft
Model number: PS-750L
16
Operation
The speed of the saw blade can be controlled with the rotary knob at the top
of the jigsaw. The higher the position, the higher the speed. The highest
position is 6.
The ideal sawing speed will depend on the profile and the tooth of the saw
blade and on the material you want to saw. For soft materials, select a
reasonably high speed and a coarse tooth. If you want to saw hard materials,
select a lower speed and a fine tooth.
Pendulum setting
Fig. 6 (also see Fig.1)
•
Soft material (wood, plastics etc.): set the pendulum to level II or III. For a
sharp saw cut, use pendulum level 0 or I.
•
Medium-hard material (hardwood, aluminium etc.): set the pendulum
depending on the application. For thin material use pendulum level 0, or I
if you are working with rasps or knives.
•
Hard material (steel etc.): set the pendulum to level 0.
•
Curves: set pendulum to level 0.
You can adjust the pendulum level while the appliance is in operation.
+
+
+
+
+