operation
UK Helpline 0905-1460005 • Ireland Helpline 1520-932626
Web Support: www.servotool.eu
Model Number: PCD-2400IK
15
Drilling
Fig.D
• Turn the torque adjusting ring (5) to the drilling position.
Ensure that the direction of rotation switch (1) is always set to ‘R’
when drilling. “R”- to the right. “L”- to the left.
Hammer drilling
Insert an undamaged drill bit into the clamping chuck. For drilling in soft
materials, such as plastic or wood, use a metal drill bit and turn the
changeover switch (Fig D., 6) to the right until the indicating mark points to
‘Drill bit’ (drilling). For hammer drilling in hard materials, such as stone and
concrete, turn the changeover switch to the left until the indicator mark
points to ‘Hammer’ (hammer drilling).
Regularly check the clamping chuck for damage. If necessary, use
coolant when drilling. When drilling in walls, bear in mind that
electrical lines and water pipes may be located inside the walls.
Switching ON and OFF
• Press the ON/OFF switch (Fig. A, 2, page 4). You can regulate the speed of
the device by means of power transmission to the switch.
• When you release the ON/OFF switch (Fig. A, 2, page 4), the drill chuck
stops immediately and does not continue to run.
• Turn the direction of rotation switch ((Fig. A, 1, page 4) to the center in
4
5