Helpline No. UK / Northern Ireland 0870 7323023 • Rep. Ireland 1800 481005
Web support: www.omegawolf.com/powercraft
Model Number: PAG-230/2100
09
Safety instructions
personal injury.
22. Have your tool repaired by an expert.
This appliance is manufactured to very high standards and meets relevant
safety regulations. Repairs should only be done by a suitable qualified
electrical engineer or otherwise.
23. Hearing protection should be worn.
Additional safety instructions
•
Check that the maximum speed indicated on the grinding disc
corresponds to the maximum speed of the machine. The speed of the
machine must not exceed the value on the grinding disc.
•
Make sure that the dimensions of the grinding disc correspond to the
specifications of the machine.
•
Make sure that the grinding disc has been mounted and fastened
properly. Do not use reducing rings or adapters to make the grinding disc
fit properly.
•
Treat and store grinding discs in conformance with the supplier’s
instructions.
•
Do not use the machine for grinding workpieces with a maximum
thickness exceeding the maximum grinding depth of the grinding disc.
•
Do not use grinding discs for deburring.
•
When grinding discs have to be mounted on the thread of the spindle,
make sure that the spindle has sufficient thread. Make sure that the
spindle is sufficiently protected and does not touch the grinding surface.
•
Before use, inspect the grinding disc for any damage. Do not use grinding
discs which are cracked, ripped or otherwise damaged.
•
Before use, let the machine run for 30 seconds. Immediately switch off
the machine if there is abnormal vibrations or occurrence of another
defect. Carefully inspect the machine and grinding disc before switching
the machine on again.
•
Make sure that sparks do not put people into danger or that they contact
highly flammable substances.
•
Make sure that the workpiece is sufficiently supported or clamped. Keep
your hands away from the surface to be cut.
•
Always wear safety goggles and hearing protection. If desired or required
also use other kinds of protection, for example an apron or helmet.
•
Ensure that mounted wheels and points are fitted in accordance with the
manufacturer’s instructions.
•
If a guard is supplied with the tool never use the tool without such a
guard.
Helpline No. UK / Northern Ireland 0870 7323023 • Rep. Ireland 1800 481005
Web support: www.omegawolf.com/powercraft
Model Number: PAG-230/2100
12
Assembly
in the required position
•
Close the clamping lever (14, page 11) to clamp the protective guard (7,
page 11).
Warning:
the closed side of the protective guard has to point towards the
user.
Rotating the handgrip
Fig. 4
The handgrip can be rotaded 90
o
regard to the machine housing. This can
result in a better control of the On/Off switch during special working
positions; for example grinding or left-hand users.
•
Pull the knob (8) backwards with thumb and forefinger.
•
Rotate the handgrip in the new position (until the blocking).
Mounting the side handle
Fig. 1
The side handle can be used for both left-hand and right-hand control.
•
Fasten the side handle (5, page 4) for left-hand operation on the right-
hand side of the machine.
•
Fasten the side handle for right-hand operation on the left-hand side of
the machine.
•
Fasten the side handle for upright working at the top of the machine.