UK Helpline 0905-1460005 • Ireland Helpline 1520-932626
Web Support: www.heltec.eu
Model Number: PCS-360/2LK
16
assembly
UK Helpline 0905-1460005 • Ireland Helpline 1520-932626
Web Support: www.servotool.eu
Model Number: PAG-115/1020
16
Prior to mounting an accessory always unplug the tool.
Assembling the hand grip
Fig. 1
The hand grip is suitable for either left or right-handed use.
• Turn the hand grip (3) to the notch on the right side of the machine for
left-handed use.
• Turn the hand grip (3) to the notch on the left side of the machine for
right-handed use.
• Turn the hand grip to the notch on the top of the machine to use it
vertically.
Disassembly
• Remove the flange nut and the grinding disc with lower flange from the
spindle.
• Unscrew the 4 screws (with washers) en remove the fixing-ring.
• Remove the guard from the machine.
Mounting a grinding disc
Fig. 2
Use grinding discs of the correct dimension. Use fibre reinforced grinding
discs only.
The grinding disc must not touch the edge of the guard.
• Press the spindle lock (6) and turn the spindle (9) until it engages in the
lock. Keep the spindle lock pressed during this procedure.
• Remove the flange nut (12) from the spindle using the spanner (11).
• Position the grinding disc (7) on the flange (5).
• Place the flange nut on the spindle an tighten it using the spanner.
• Release the spindle lock and check that the spindle is unlocked by rotating
it.
Mounting grinding discs and roughing discs
Fig. 4 and 5 show how to mount the flange (10) when using thick (4 – 8 mm)
and thin (2,5 – 4 mm) discs.
The following grinding discs can be used with this grinder.
