Safety instructions
UK Helpline 0905-1460005 • Ireland Helpline 1520-932626
Web Support: www.servotool.eu
Model Number: PAG-115/1020
12
be different from grinding wheel flanges.
e) Do not use worn down wheels from larger power tools.
Wheel intended
for larger power tool is not suitable for the higher speed of a smaller tool
and may burst.
Additional Safety Warnings Specific for Abrasive Cutting-Off Operations:
a) Do not “jam” the cut-off wheel or apply excessive pressure. Do not
attempt to make an excessive depth of cut.
Overstressing the wheel
increases the loading and susceptibility to twisting or binding of the
wheel in the cut and the possibility of kickback or wheel breakage.
b) Do not position your body in line with and behind the rotating wheel.
When the wheel, at the point of operation, is moving away from your
body, the possible kickback may propel the spinning wheel and the power
tool directly at you.
c) When wheel is binding or when interrupting a cut for any reason, switch
off the power tool and hold the power tool motionless until the wheel
comes to a complete stop. Never attempt to remove the cut-off wheel
from the cut while the wheel is in motion otherwise kickback may occur.
Investigate and take corrective action to eliminate the cause of wheel
binding.
d) Do not restart the cutting operation in the workpiece. Let the wheel
reach full speed and carefully reenter the cut.
The wheel may bind, walk
up or kickback if the power tool is restarted in the workpiece.
e) Support panels or any oversized workpiece to minimize the risk of wheel
pinching and kickback.
Large workpieces tend to sag under their own
weight. Supports must be placed under the workpiece near the line of cut
and near the edge of the workpiece on both sides of the wheel.
f) Use extra caution when making a “pocket cut” into existing walls or other
blind areas.
The protruding wheel may cut gas or water pipes, electrical
wiring or objects that can cause kickback.
Special safety instructions
• Check that the maximum speed indicated on the grinding disc corresponds
to the maximum speed of the machine. The speed of the machine must
not exceed the value on the grinding disc.
• Make sure that the dimensions of the grinding disc correspond to the
specifications of the machine.
• Make sure that the grinding disc has been mounted and fastened
properly. Do not use reducing rings or adapters to make the grinding disc
