32
GB
Setup
This submersible pump is intended for use
as a cellar pump to protect against flooding
and for removal of water in domestic
situations, e.g. in gardens, greenhouses, etc.
There must be sufficient space around the
pump for the float to move freely.
Place the pump in the required location and
then plug it in.
The pump must be on a level surface, so
that there is no risk of it tipping over while
in operation.
The pump can be fully or partially
submerged in water. Tie a piece of rope
around the carrying handle, if necessary,
before submerging in deep water, and also
check that the cord is long enough for the
water depth.
The pump must not be left suspended by its
cord or hose.
Fit a check valve in the pipes, if necessary,
to prevent any backflow of water when the
pump is stopped.
Technical data
If you are using a collecting vessel, you
should check that it is large enough to
hold the pumped liquid, so that it is not
necessary to interrupt operation of the
pump.
If the pump is being used in a garden pond
containing fish, you must make sure that
the fish cannot be sucked into the pump.
Use
The pump can be set to automatically
switch on and off at specific water levels.
When adjusting the float, it is essential
to do this in a location where it is easily
accessible. The pump can, for example, be
placed in a bowl of water. Position the float
in the holder. Lift the float to the maximum
position, so the pump begins to run. Lower
the float slowly to the minimum position,
until the pump switches off. Remember to
make sure that the pump stops before the
float touches the bottom; otherwise the
pump will run dry and could be damaged.
Check that the pump’s connections fit
tightly.
Model
79890
79895
79992
79994
Designation
SUBMERSIBLE CLEAN
WATER PUMP
SUBMERSIBLE DIRTY
WATER PUMP
Voltage/frequency
230 V ~ 50 Hz
Power rating
250 W
550 W
550 W
1,100 W
Capacity
5.000 l/hour
10,500 l/hour 10,500 l/hour
15,500
l/hour
Max. pump depth
5 m
7 m
7 m
8 m
Max. delivery head
6 m
7 m
7 m
11 m
Max. water temp.
35 °C
Max. particle size
For clean water only!
25 mm Ø
Automatic floating
switch
For: max. 50 cm
From: min. 5 cm
Hose connector
¾”
1½”
Connection
With 10 m rubber cable
