Power Craft 26182, Инструкция по эксплуатации

Страница: 20 / 30

20
ENGLISH
INSTRUCTION MANUAL
Adjusting the direction of rotation
Always check the direction of rotation of the
chuck before using the screwdriver.
Set the changeover switch to forward to make the
chuck turn clockwise (screw driving).
Set the changeover switch to reverse to make the
chuck turn counter-clockwise (unscrewing).
The direction of rotation can only be changed
when the chuck is not turning.
Start, stop and speed control
Start the screwdriver by pressing the on/off trigger.
The chuck begins to rotate.
The longer the trigger is pressed, the faster the
chuck rotates.
Stop the screwdriver by releasing the trigger.
By turning the knob that regulates maximum
speed (5), you can adjust the speed of the
screwdriver when the trigger is fully depressed.
Constant operation
Start the screwdriver as described. Once the
trigger is fully depressed, press and hold the lock
button. Now release the trigger and then the lock
button. The chuck will now rotate continuously at
the set maximum speed.
Constant operation can be interrupted by pressing
the trigger in fully, which releases the lock button.
The screwdriver stops when the trigger is released
again.
Fitting and removing the screw belt
adapter
Loosen the chuck and insert the long screwdriver
bit (A). Tighten the chuck.
Slide the screw belt adapter on over the chuck and
turn it to the left, so that it connects with the
screwdriver's guide notch.
Pull the screw belt through the screw belt guide,
and insert it into the screw belt feed, so that the
screws in the belt line up with the screwdriver bit.