11
ENGLISH
INSTRUCTION MANUAL
Introduction
To get the most out of your new electric hoist,
please read this manual and safety instructions
before use. Please also save the instructions in case
you need to refer to them at a later date. Go to
www.powercraft.com for further information on
our products.
Technical data
Voltage/frequency:
230 V ~ 50 Hz
Power rating:
500 W
Cable:
length 12 m, diameter 4 mm
Max. load:
100 kg (single cable)
200 kg (double cable)
Rewind speed:
10 m/min
Net weight:
18 kg
Main components
1. Remote control with hoist/lower button
2. Motor
3. Drum
4. Pulley and hook
5. Hook and stop block
6. Mounting brackets
7. Bolts, nuts and washers
Special safety instructions
Protect from frost and low temperatures.
Check that the cable is correctly wound onto the
drum before each use (see illustration on right),
that the hoist is mounted correctly and that the
remote control works correctly.
Never use if the cable is worn, frayed or defective.
Replace cable with a new one of the same type
before using the hoist again.
Do not wind more than 15 metres of cable onto
the drum.
Always ensure that there are at least three cable
windings on the drum.
Check that the item is secure on the hook before
raising it.
Avoid loading the hoist beyond its max. capacity.
If the hoist cannot lift an item, it is because it is
too heavy. Release the hoist button on the remote
control, reduce the load or find another way to lift
it. Allow the motor to cool off before using the
hoist again.
Never stand underneath the item being lifted or
when it has been lifted.
Never leave or switch the hoist off while it has an
item raised. Remove the item from the hook and