Power Climber Wind BAP 360, Инструкция по эксплуатации и монтажу

Страница: 29 / 37

Reference: 38741 Issue date: 2018-JUL-24 Revision: L Page 29 of 37
9. Reeving of Steel Wires
A. Reeve the suspension ropes in the TITAN hoist
At roof level, uncoil the suspension ropes and lay them on the roof surface. Attach
the suspension ropes to the suspension system with the safety hooks fitted to the
ropes and lower the ropes to the ground. Verify that the
rope is long enough.
Tip: Before reeving the suspension rope, check that the
overspeed safety device is reset by turning the yellow reset
knob in the direction of the arrow (clock-wise).
1. Push back the slack rope lever and insert the
suspension rope through the eye of the slack rope lever and
into the hoist until it stops.
2.
Push the ‘up’ button on the Control panel and the steel
wire rope passes through the hoist automatically. The end of
the rope will come out from the bottom of the hoist. Make
sure the outlet is free and the wire rope can come out.
Tip: If there is any difficulty reeving the suspension rope it
helps to put a small bend in the end of the rope before
feeding it into the hoist.
B. Attach the TITAN hoist to the stirrup
1. Lift the TITAN up from the ground by pushing
the ’up’ button on the Control panel. Line up the
holes in the stirrup bar with the holes in the
stirrup.
2.
Attach the TITAN hoist to the stirrup of the
platform with M12 bolts and self-locking nuts.
Make sure that the TITAN hoist is mounted with
the main hoist label towards the inside of the
platform.