24
VII. TROUBLESHOOTING
First ensure all set up steps have been followed.
(See Page 6)
Atomizer not draining properly:
• Adjust drain hose to ensure curve of hose is sloping downward into the tank.
Drain hose should not be angled too sharply and it should not be drooping
too much as this could cause backage in the hose. Also, ensure the drain hose
is not submerged below the water line in the tank.
Atomizing disk is spinning, but there is no water:
• First, verify that the water pump is clean and running. (See Page 20)
• If water is not running, check the connection by removing the
water inlet
hose
from the
bulkhead fitting
in the fan head. Ensure that water is flowing
at this end, if it is not flowing at this end then check for blockages within the
tubing. (See Page 16, Image 3)
• If water is running, but there is no water pumping, the problem is mechanical.
Check for the following:
• Check that the water valve is open. (See Page 11, Image 2)
• Check that the tubing is connected to the pump.
• Verify that the pump is clean and running. (See Page 20)
• If the above steps fail, the pump must be replaced – contact us.
1-
844-233-5673 |
Unit shuts off:
• If your Power Breezer shuts off unplug it. Wait 20 seconds, then plug it back in
and restart your unit.
Unit will not roll:
• Ensure rear wheel brakes are in the OFF position.
Unit is plugged in, and powered on, but the LED lights are off:
• The LED lights dimming feature may have been activated. The LED lights may
have to be brightened. (See Page 14)
Troubleshooting
ENGLISH
