The fixture can be used in a store front display to attract the attention of potential customers, but
it may not be effective during certain day time hours of direct sunlight.
The fixture should not be located where it could be knocked over by passing people or pets, or in
areas that may be conducive to people inadvertently fouling the device project screen.
Wall mounting
The PowellColorBox Ambiance Mood Panel is supplied with a pre-mounted support wire intended
for hanging the fixture in a vertical orientation. Care must be taken that the wall mounting point
can safely manage the weight of the fixture which is 11.4 lbs (5.2 kg). One should use either a
sturdy wood screw secured directly in a wall stud or use the dry-wall mount device which is
supplied with the fixture.
The Ambiance Mood Panel can also be mounted in a horizontal orientation. This done using the
Eagle “Z” clips which are supplied with the fixture. The Z clips must first be attached to the back
of the fixture using the four wood screw which are supplied. Then the other two “Z” clips must be
attached to the wall such that the clips are 35
¼” (895 mm) apart as measured edge to edge, or
37 ¼” (946 mm) apart as measured from clip center to clip center.
Mount the Eagle Clips to the wall in the desired location using fasteners which are appropriate for
the specific wall material.
The distance between the Eagle Clips should be according to the chart below. The mounting
distances are given in both center to center, and as distance between the inside edges of the
clips.
It is important that the clips are installed along a horizontal line which is level. The best way to
achieve this is to draw a
line on the wall using a carpenter’s level. If a level is not available,
then measure the mounting height of each clip from either the floor, ceiling, or other known level
reference.
Please note that the power cord should be attached to the wall using a convenient mounting
system such as D-Line Cord Cover or Legrand WireMould. The cable supplied with the fixture,
and the power supply itself, are not intended for installation within walls.
Set up for free-standing application using the optional floor stand
The Ambiance Mood Panel can be used in a self standing fashion through the use of the optional
floor stand.
The Floor stand consists of a base, two connecting rods, and mounting panel.
The floor stand should be assembled first. Start by inserting the two rods into the base unit,
twisting the rods until they are fully seated, then slip the mounting panel onto the exposed ends
of the two rods, and press it firmly into place.
The easiest manner to attach the floor stand to the Ambiance Mood Panel is to lay the fixture face
down on a table or other elevated surface such that the bottom of the fixture is near an edge of
