9
OPERATION
Drive speed control lever -
used to select forward or
reverse motion and speed of snow thrower.
Traction drive control lever -
used to engage power-
pro pelled for ward or reverse motion of snow thrower.
Auger control lever -
used to engage auger motion (throw
snow).
Discharge chute control lever -
used to change the di-
rec tion the snow is thrown.
Skid plate -
used to adjust height of scraper bar from the
ground.
Deflector remote control lever -
used to change the
dis tance the snow is thrown.
Toolbox -
used to store spare shear bolts, locknuts and
wrench.
Safety ignition key -
must be inserted for the engine to
start and run. Remove when snow thrower is not in use.
Electric start button -
used for starting the engine.
Recoil (auxiliary) starter handle -
used for start ing en gine.
Primer -
pumps additional fuel from the carburetor to the
cylinder for use when starting a cold engine.
Choke control -
used for starting a cold engine.
ON / OFF switch -
used to STOP the engine.
LH and RH turn triggers -
used to steer the snow thrower.
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
MUF FLER
TOOLBOX
HANDLE
KNOB
CHUTE
DE FLEC TOR
DISCHARGE
CHUTE
AU GERS
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY
VARY WITH THE
ENGINE ON YOUR
UNIT.
FIG. 10
CLEAN-OUT TOOL
SKID PLATE
LIGHT
DEFLECTOR REMOTE
CONTROL LEVER
TRACTION
DRIVE
CONTROL
LEVER
DISCHARGE CHUTE CONTROL LEVER
DRIVE SPEED
CON TROL LEVER
AUGER
CONTROL
LEVER
FUEL SHUT-OFF VALVE
ON / OFF
SWITCH
MUF FLER
GAS O LINE
FILLER CAP
SAFETY
IGNITION
KEY
CHOKE
CON-
TROL
PRIM ER
RECOIL (AUXILIARY) STARTER HANDLE
ELECTRIC
START
BUTTON
POWER
CORD
PLUG
LH TURN
TRIGGER
