-- 3 --
D
Disconnect spark plug before performing
maintenance except for carburetor adjust-
ments.
D
Use only recommended
Poulan PRO
re-
placement parts; use of any other parts
may void your warranty and cause damage
to your unit.
D
Empty fuel tank before storing the unit. Use
up fuel left in carburetor by starting engine and
letting it run until it stops.
D
Do not use any accessory or attachment
other than those recommended by manufac-
turer for use with your unit.
D
Do not store the unit or fuel in a closed area
where fuel vapors can reach sparks or an
open flame from hot water heaters, electric
motors or switches, furnaces, etc.
D
Store in a dry area out of reach of children.
SPECIAL
NOTICE:
Your
blower
is
equipped with a temperature limiting muffler
and spark arresting screen which meets the
requirements of California Codes 4442 and
4443. All U.S. forest land and the states of
California, Idaho, Maine, Minnesota, New
Jersey, Oregon, and Washington require by
law that many internal combustion engines be
equipped with a spark arrestor screen. If you
operate a blower in a state or locale where
such regulations exist, you are legally re-
sponsible for maintaining the operatingcondi-
tion of these parts. Failure to do so is a viola-
tion of the law.
SAFETY NOTICE:
Exposure to vibrations
through prolonged use of gasoline powered
hand tools could cause blood vessel or nerve
damage in the fingers, hands, and joints of
people prone to circulation disorders or ab-
normal swelling. Prolonged use in cold
weather has been linked to blood vessel dam-
age in otherwise healthy people. If symptoms
occur such as numbness, pain, loss of
strength, change in skin color or texture, or
loss of feeling in the fingers, hands, or joints,
discontinue the use of this tool and seek
medical attention. An antivibration system
does not guarantee the avoidance of these
problems. Users who operate power tools on
a continual and regular basis must monitor
closely their physical condition and the condi-
tion of this tool.
ASSEMBLY
CARTON CONTENTS
1. Outlet Tube
2. Flexible Tube
3. Hose Clamps
4. Control Handle
5. Base Tube
6. Middle Tube
7. Air Nozzle
8. Throttle Cable
9. Throttle Cable Clamp
1
2
3
5
6
4
7
8
9
WARNING:
If you receive your unit
assembled, check each step to insure your
unit is properly assembled and all fasteners
are secure. Follow all safety information in
the manual and on the unit.
1. Locate and identify all components.
2. Connect the flexible tube to the outlet tube
on the engine. Tighten the hose clamp.
3. Remove bottom screw from control han-
dle. Install the control handle against the
flared area on the base tube with the ON/
STOP switch facing the engine.
4. Connect the base tube to the flexible tube.
Tighten the hose clamp.
5. Assemble the air nozzle to the middle
tube and connect the assembly to the
base tube by pushing the tubes together
and turning them until they lock in place.
6. Remove throttle cable clamp from flexible
tube. Place throttle cable in clamp and re-
install on flexible tube.
