7
The operation of any tiller can result in foreign objects thrown into the eyes, which can result in
severe eye damage. Always wear safety glasses or eye shields before starting your tiller and while
tilling. We recommend a wide vision safety mask for over spectacles or standard safety glasses.
00155
TILLING
The speed and depth of tilling is regulated by the position
of the depth stake.
The depth stake should always be below the wheels for
digging. It serves as a brake to slow the tiller’s forward
motion to enable the tines to penetrate the ground. Also,
the more the depth stake is lowered into the ground the
deeper the tines will dig.
DEPTH STAKE (See Fig. 7)
Adjust depth stake by removing the hairpin clip and clevis
pin. Change depth stake to desired position. Replace the
clevis pin and hairpin clip.
•
For normal tilling, set depth stake at the second or third
hole from the top.
Fig. 7
HOW TO USE YOUR TILLER
Know how to operate all controls before adding fuel and
oil or attempting to start engine.
STOPPING (See Fig. 6)
TINES
1. Release tine control to stop move ment.
ENGINE
2. Move throttle control to "STOP" position.
TINE OPERATION (See Fig. 6)
• Squeeze tine control to handle.
Fig. 6
OPERATION
TO TRANSPORT
CAUTION: Before lifting or trans port-
ing, allow tiller engine and muffler to
cool. Disconnect spark plug wire. Drain
gasoline from fuel tank.
AROUND THE YARD
• Adjust depth stake so clevis pin is in bottom hole.
• Push tiller handles down, raising tines off the
ground.
• Push or pull tiller to desired location.
AROUND TOWN
• Disconnect spark plug wire.
• Drain fuel tank.
• Transport in upright position to prevent oil leakage.
DEPTH
STAKE
HAIRPIN
CLIP
CLEVIS PIN
TINE CONTROL
“OFF” (UP) PO SI TION
TINE CONTROL
“ON” (DOWN) PO SI TION
THROTTLE
CONTROL
