Pottinger EUROCAT 275 H-ED, Руководство оператора, Страница: 15 / 51

- 15 - 0400-GB Schnitthöhe_344
GB
STARTING WORK
Operation
1. Adjust cutting height by turning upper link spindle
(inclination of the cutting discs max. 5°).
Cutting height adjustment
The cutting height can be set anywhere from 35 to 65 mm by adjusting
the centre disc.
1. Lift unit with loader (~5 cm).
2. The key (W) is put on the square or hexagon and turned until the
required cutting height is set.
Turn once = 1,5 mm
Cutting height adjustment
Safety points
- Turn engine off when
adjustment, service and
repair work is to be done.
- Do not work under the
machine without safe
support.
- Retighten all screws after
the first hours of operation.
Distance plates
• The cutting height is set by inserting distance plates (4mm,
6mm).
2 of which have already been inserted (4mm, 6mm) in the
factory.
Optional equipment: 8 distance plates (6mm)
Optional equipment: high-cut mowing plate (H1)
• Each mowing drum must have an equal number of plates
inserted.
Inserting distance plates
1. Remove both skide plates (S1, 1a).
2. Insert distance plates (6mm).
3. Refit both skid plates.
Replace worn or damaged spring lock washers with new ones.
Similarly with worn screws and nuts.
Tighten all screws firmly!
4. Check after the first hour of operation
Check all screws for tightness.
TD 79/99/10
~ 5cm
TD 79/99/05
099-02-06