Date: 17‐Nov‐15
www. potterybarn.com
Page 5 of 8
Rev:
2. Basin
installation:
1)
Place the L shape brackets (G), top washer and nut in succession through the other end of anchor. Secure by
tightening the nut with a wrench.
Note:
position the basin (A) squarely under the cutout before fixing L shape brackets tightly, don’t tighten the
brackets at this stage.
2)
Apply a continuous bead of high quality silicone or acrylic based bath sealant to the basin rim where it will
contact the countertop.
DO NOT USE PLUMBERS PUTTY OR ANY OIL BASED SEALANT AS THIS WILL
STAIN THE MARBLE. Note: Don’t use adhesives or adhesive sealants.
Draw the basin rim up to the countertop until it is snug.
CAUTION: TO AVOID BREAKAGE, DON’T OVER-TIGHTEN WITH WRENCH.
Immediately wipe away any excessive sealant.
3. Leveler
adjustment:
Note:
Before installing marble top onto console base; console needs to be properly leveled, shimmed (if
necessary), and secured to floor and wall as required.
Levelers are pre-installed on the corner of bottom console and adjust as needed to make sure the console is
level. Turn counter-clockwise to increase height, clockwise to decrease height.
G
A
B
C
