4. Once the toggles are installed into the wall at the marked locations, reposition the wall bracket so that the
marked holes of the bracket align with the toggles. Using the supplied toggle screw secure the bracket to
the installed toggles. Note: The toggle includes a nut portion that must be “set” into a locked position prior
to using the product. This is done automatically as you rotate the toggle screw into the toggle, but keep in
mind that the screw must be rotated quite a few times before the nut finally reaches this locked position.
The nut will create resistance when it reaches the locked position within the wall.
5. Once the wall bracket is attached to each toggle using the toggle screw, the bracket must be secured to the
stud located along the bracket. Use the supplied stud mount screw to secure the wall bracket to the stud
(note, a pre-drilled hole of the bracket should align with the stud location).
Figure 1
HANG THE PRODUCT ONTO THE MOUNTED WALL BRACKET
1. On the back of your product is an affixed product-mounting bracket.
2. With the help of another person, carefully position the product-mounting bracket slightly above and against
the wall mount bracket, insuring that the two brackets are aligned. Engage the two brackets.
3. With a pencil, mark on the wall through the location of the lower mounting point.
4. Remove the cabinet. Use the marked point as the insertion point for the small anchor. Place the #2
Phillips screwdriver into recess of the anchor. Slowly turn the anchor clockwise while applying pressure
until the flange just touches the wall.
5. Again, carefully position the product-mounting bracket slightly above and against the wall mount bracket,
insuring that the two brackets are aligned.
6. Press down firmly to engage the two brackets.
7. Insert the small screw through the pre-drilled hole inside the cabinet. Tighten against wall. Cover the
screw head with plastic plug.
SHELF INSTALLATION:
1. Insert shelf brackets into coordinating holes at desired level. Align the bottom slots of each shelf with the
corresponding holes. Push down to secure.
