Potterton Medway Super, Инструкция по установке и обслуживанию

Страница: 8 / 23

8
4. COMMISSIONING – Page 8
NOTE: If a gas rate check is required, the gas
consumption after 3 minutes running
should be approximately 48.5 l/mm
(1.7 ft
3
/min).
9. Turn the temperature selector spindle from right to left
(‘+’ to ‘-‘), there will be a noticable change in the outlet
temperature. Turn the rod back to the right (‘+‘).
10 Turn OFF the hot water outlet and press the OFF
button’ ‘on the appliance. Remove the pressure
gauge and replace the screw and sealing ring.
11 Relight the pilot. Turn ON a hot water outlet and check
for gas soundness at the pressure test point.
12 Turn OFF the hot water outlet. Slide the bottom cover
onto the appliance. Ensure that the temperature selector
spindle is aligned with the selector knob, push the
bottom cover and with slight adjustment the selector will
positively locate on the spindle.
Fig 12
Explain to the user how to operate the appliance.
- see the “Instructions for Use” booklet.
Show the user the position of the Identification Badge.
HAND OVER THE “INSTRUCTIONS FOR USE” TO ThE
USER.
LEAVE THESE “INSTALLATION AND SERVICE”
INSTRUCTIONS WITH THE USER
FOR USE ON FUTURE CALLS.
ADVISE THE USER THAT FOR CONTINUED
EFFICIENT AND SAFE OPERATION OF THE
APPLIANCE, IT IS IMPORTANT THAT
SERVICING IS CARRIED OUT AT
INTERVALS RECOMMENDED BY THE
LOCAL BRITISH GAS REGION OR C.O.R.G.I.
REGISTERED INSTALLER.
Fig 13
5. SERVICING – page 8
To ensure continued efficient operation of the appliance, it is recommended that it is checked and serviced as necessary at
regular intervals. The frequency of servicing will depend upon the particular installation conditions and usage, but in general
once per year should be adequate.
IMPORTANT: It is the law that any service work must be carried out by competent persons such as British Gas or other
c.o.r.g.i. registered personnel.
NOTE: In hard water areas, scale may build up on the push rod , seals and on the underside of the diaphragm housing.
They may require regular descaling and regreasing.