7. Locking Feature
The PAD100-PD, PAD200-PD, PAD100-PHD, PAD200-PHD, PAD200-PCD,
PAD200-PCHD, PAD100-HD and PAD100-CD include a tamperproof feature
that locks the detector and does not allow removal without the use of a tool.
1. Once the detector has been installed the detector locks into the base.
To remove the detector from the base, insert a small screwdriver
into the slot on the detector (FIGURE 6) and push the plastic tab while
simultaneously turning the detector head counter-clockwise.
2. The locking feature can be disabled. To disable the locking feature,
break off the locking tab before installation (FIGURE 7).
8. Detector Base Options
NOTE:
Installation instructions for PAD100-DUCTR, reference docment
number 5406321-A.
Installation instructions for PAD100-DUCT, reference document
number 5406322-A.
Installation instructions for PAD200-DUCTR, reference docment
number 5406429-A.
Installation instructions for PAD200-DUCT, reference document
number 5406428-A.
9.
Detector will not operate without electrical power. Fire can cause
power interruption, discuss with a fire protection specialist for
additional safeguards.
Do not open PAD100-PHD, PAD200-PHD, PAD100-HD PAD200-PCD,
PAD200-PCHD, or PAD100-CD
detector for cleaning. If the detector is opened, product warranty
becomes void.
If the detector does not work properly, do not try and fix it yourself.
This will void your warranty. For techincal assistance, contact
Potter Electric Signal Company at 866-956-1211 for instructions to
return a detector that does not operate properly.
Detector will not sense fires that start in areas where smoke or heat
cannot reach the detector. Smoke or heat from fires in walls, roofs
or on the opposite side of closed doors may not reach the detector.
Keep supplied dust cover in place during installation and construction.
Remove dust cover prior to operation.
Dust cover is not a substitute for removal of detector during new
construction or remodeling.
The detector cannot detect smoke when the dust cover is in place.
Never use an open flame of any kind to test your device. You may
ignite and damage the detector.
Do not cover, tape or otherwise block the openings of your detector.
The openings are designed to allow air to pass through the detector,
thus sampling the air around the detector.
Detectors are not to be used with detector guards unless the
combination has been evaluated by a nationally recognized testing
laboratory and found suitable for that purpose.
To ensure proper operation, store detector within the
recommended ranges. Allow the detector to stabilize to room
temperature before applying power.
If the detector ever fails to test properly, replace it immediately.
Products under warranty may be returned to the manufacturer for
replacement, see LIMITED WARRANTY.
For technical assistance, contact Potter Electrical Signal Company at
1-866-956-1211
WARNING
!
FIGURE 6: Locking Feature
Insert small
screwdriver into slot
to remove detector
from base
FIGURE 7: Disable Locking Feature
Break off tab (gray area) in image
to disable locking feature.
Model
Description
PAD100-6DB
6 inch detector base.
PAD100-4DB
4 inch detector base.
PAD100-IB
6 inch detector base with short circuit isolator.
See manual number: 550-0671-000
PAD100-RB
6 inch detector base with relay module.
See manual number: 550-0671-000
PAD100-SB
6 inch detector base with sounder module.
See manual number: 550-0671-000
PAD100-LFSB
6 inch detector base with low frequency sounder module.
See manual number: 550-0706-000
PAD100-SPKB 6 inch detector base with speaker module.
See manual number: 550-0706-000
