4
2.
Before installing
2-inch paper roll
in the thermal printer, follow the
instructions below to properly install plastic pad spacer and the
separator.
If you are using 3” paper roll for the printer, please
skip to next step.
The application of 58 mm width (2-inch) paper roll in this printer can be
achieved through adoption of an option spacing plate and an internal DIP
switch setting. Please contact the service team for the DIP switch setting.
Please refer to the middle picture above for the 58 mm paper spacing plate
with its flange at top edge showing out. Insert the noted corners of the
spacing plate into the 3 dents inside the paper roll compartment as arrowed
in the left picture above with point A goes in first. Then the 58 mm paper
roll sub compartment is formed as in the right picture above.
3.
To load the thermal printer with
the 3-inch
paper roll
, make sure the plastic pad is
removed from the printer compartment. Then,
carefully drop the thermal paper roll inside
the paper roll compartment of the printer as
illustrated in the figure.
4.
Unroll the thermal paper and drag the loose
end of the paper till it extends towards the
paper cutter.
