Powering ON/OFF your Monitor
To start up LM/TM-30XXE/32XXE, you have to make sure that the monitor is
well connected to POS terminals and electricity is supplied to the monitor
either through POS terminal or through external power sources. For the users
who prefer Posiflex POS terminal as primary power sources to power your
monitor using VGA cable, please also refer to the
Activating Power Output
to VGA Port via BIOS Settings
section to confirm that VGA port of your
terminal is indeed enabled.
Power ON LM/TM-30XXE/32XXE
Press the power button of the terminal to power up the terminal. Few seconds
later the monitor will be initiated automatically.
Power OFF LM/TM-30XXE/32XXE
After following the standard shutdown procedure to shut down your terminal,
the monitor will be consequently turned off.
Activating Power Output to VGA port via BIOS Settings
In general, Posiflex terminals will disable the VGA controller in BIOS due to
safety concerns. In the case of using your terminal to supply power to monitors,
it is required to manually enable the VGA output of the terminals in BIOS
settings so that the monitor is able to extract power from the Posiflex terminals.
However, if the monitor you are using is not manufactured by Posiflex, it is
strongly suggested to deactivate the VGA port of your terminal in preventing
your device from being damaged.
The following will describe the steps required to enable VGA port in BIOS
setting. Also, please DO NOT plug the VGA cable into VGA connectors while
the terminal is still running.
1.
Make sure that LM/TM-30XXE/32XXE is well connected to the Posiflex
terminals using the VGA cable.
2.
Press the power button of the POS to power on the POS. During the boot
process, hit
F2
key to access BIOS setting.
3.
Navigate through BIOS using arrow and Enter keys to access the setting
of VGA port. If it is set to be disabled, hit
Enter
key to enable the VGA
port.
4.
Switch to
Exit
tab and select
Exit Saving Changes
option. Choose
Yes
in
Setup Confirmation message box to save your configurations.
5.
After rebooting your POS, make sure the monitor is correctly detected.
15
Содержание LM-30 Series
Страница 20: ... MEMO 20 ...
