KS-6615 / KS-6617 series Technical Manual 5 - 8
AUTOMATIC POWER ON CONTROL
When the system is turned off after a successful boot up, the preset automatic
power on functions if set as below will keep monitoring for the preset conditions and
turn on the system when the preset conditions are met.
Please note that if the system is improperly turned off before a complete boot
up procedure, the mentioned preset power on control functions will be disabled until
next turning off after a complete boot up.
ALARM CLOCK WAKE UP
To utilize Alarm Clock Wake Up function, the user should enter the CMOS
setup by pressing “Del” key at system boot up, choose for “Power Management
Setup” and make the “Resume by Alarm” enabled and set the alarm to required time.
Save the configuration and exit the CMOS setup program. The Preset Power On
Control will then be ready.
MODEM RING UP
To utilize Modem Ring Up function, the user should enter the CMOS setup by
pressing “Del” key at system boot up, choose for “Power Management Setup” and
make the “Power On by Ring” enabled and connect the RS232 modem to any COM
port. Save the configuration and exit the CMOS setup program. The Preset Power On
Control will then be ready.
LAN WAKE UP
The LAN Wake Up function is supported under pure DOS environment only. It
is not applicable to Windows DOS or Command Prompt Mode. To utilize Modem
Ring Up function, the user should enter the CMOS setup by pressing “Del” key at
system boot up, choose for “Power Management Setup” and make the “Wake-Up by
PCI card” enabled. Save the configuration and exit the CMOS setup program. In this
application, there needs to be 1 master machine and 1 target machine connected
together through LAN. Both machines should be using same brand of LAN chip.
First the MAC address of the target machine should be checked. Please obtain
the file “RSET8168.EXE” from Posiflex Product Information CD in subfolders like
