Part 9
optional UPS battery.
Note: Never
press the HDD hold spring carelessly or
system damages
could
occur
. The
user
shall be
responsible
for
such kind of damage
.
INSTALLING UPS BATTERY (OPTION)
When the FT-6315 system is ordered
with the UPS battery, the UPS battery is
separately stored in the carton at delivery.
Please take it out and place it into the battery
compartment by first pressing down the UPS
battery hold spring and then allow the spring to
spring back and hold the UPS battery in the
compartment as indicated by lower rectangle in
picture at right. Connect the cable to its
connector above the battery compartment in correct orientation (observe the
shape of the connector – red wires at left)
only when the system is about to
power up for operation
.
Always disconnect the UPS battery
when the
system is to be left powered off for more than few days. Please pay particular
attention to the environment requirement for UPS battery in next chapter
“USING THE TOUCH TERMINAL”.
CONNECTING CASH DRAWER (OPTION)
The RJ11 connector in main connection area of a FT-6315 system can
be used for controlling most of the common cash drawers available on the
market. However, it is most recommended that the Posiflex CR-2000 or CR-
2200 or CR-3100 or CR-3200 or CR-4000 or CR-4100 or CR-4210 or CR-
6200 be used for best compliance.
The FT-6315 system will directly control the cash drawer using the
cash drawer port (CR) both to operate the opening mechanism and to monitor
the drawer open status. Both functions may be accomplished under software
control of the COM1 serial port.
Use the cable supplied with the cash drawer (Part No. 21863018010)
for connection to the CR port in FT-6315 system. This cable has a 6-pole plug
at one end and an 8-pole plug at the other. The 8-pole plug should be inserted
into the connector marked: “signal cable from POS Printer” at the rear of the
cash drawer. The 6-pole plug should be inserted in the connector marked “CR”
found in the main connection area in the system.
The user may also use the optional 2-in-1 cash drawer control cable
CCBLA-238 to control 2 cash drawers in 1 port. It has a 6-pole plug at one end
and two 8-pole plugs at the other. The 6-pole plug should be inserted in the
connector marked “CR” found in the main connection area in the system. Each
8-pole plug should be inserted into the connector marked “signal cable from
UPS Battery Compartment
UPS Battery Connector
