5 - 4
For switch position 5, if the switch is set to ON, the busy
signal is sent to host only when input buffer is full. When it is set
to OFF, busy signal is sent to host whenever an off line status
occurs. Therefore, signals including the paper near end detect will
generate busy signal to the host. Consequently, the printing may
be stopped even when there is still a long way to go before the
paper roll is actually exhausted. Taking the paper out beep into
consideration, the printer will keep on beeping at Paper End
(completely no paper) till paper is replaced when S1-5 is ON. Yet
when S1-5 is OFF, the printer will keep on beeping every 3
seconds at Paper Near End (still long paper in replace) till paper is
replaced.
For switch position 6, when it is set to OFF, there will be a
20 mm paper feed before cutting when software does not define
this point and there will be further 10 mm paper after cutting to
prevent paper jam. Before setting this switch to ON, please make
sure that your software will take care of enough paper feed for the
paper jam prevention issue.
For switch position 8, when it is set to ON in the field, the
printer maybe subject to unpredictable damages and must be
strictly prevented.
The factory default for each position is listed below:
Switch Position
1
2
3
4
5
6
7
8
Serial interface w/
auto cutter
OFF OFF OFF OFF OFF OFF OFF OFF
Parallel interface w/
auto cutter
ON ON OFF OFF OFF OFF OFF OFF
C.
ADVANCED SETTINGS
Please consult your system integrator once any advanced
settings like that for using 38 mm width paper roll in PP-5000
models.
