Page 17
For switch position 5, if the switch is set to “ON”, the busy signal set to host
only when input buffer is full. When it is set to “OFF”, busy signal is sent to
host whenever the input buffer is full or an off line status occurs. Therefore,
signals including the paper near end detect will generate busy signal to the host.
Moreover, the printer will keep on beeping at Paper End (completely no paper)
till paper is replaced when S1-5 is “ON”. When S1-5 is “OFF”, the printer will
keep on beeping every 3 seconds at Paper Near End (still long paper in replace)
till paper is replaced.
For switch position 6
,
when it set to “OFF”, the paper will feed before cutting
when software does not define this point and there will be a further paper
feeding after cutting to prevent paper jam. Before setting this switch to “ON”,
please make sure that your software will take care of enough paper feed for the
paper jam prevention issue.
Switch position 7 defines the auto cutter. When needs to enable the paper auto
cut function, it have to place to “Off”. On the other hands, the auto cutter
function will disable when it place at “On”.
Switch position 8 defines the firmware update function. If the printer needs to
update the firmware, please set to “ON” position. In order to operating
perfectly, please set in “OFF” when the printer do not needs to update the
firmware or in normal situation.
The factory default for each position listed as below:
Switch 1 Position
1 2 3 4 5 6 7 8
Default setup for
Aura-6800L
OFF OFF OFF OFF OFF OFF OFF OFF
Default setup for
Aura -6800/P/U
OFF ON OFF OFF OFF OFF OFF OFF
Software switch
Another method to setup Aura-6800 is through the software switch setting,
which means other functions must be change by software utility. The
information below applies to the latest version to the date of print of this
manual. Please visit our web site
http://www.posiflex.com
or
http://www.posiflex.com.tw
for download the
Aura-6800 software switch
utility.
Software switch has divided into
SW2
and
SW3
. Following
information is going to describe these settings.
SW2 software switch works as following:
