Posi Pin CR-R885-A, Инструкция по установке и эксплуатации

Страница: 7 / 16

PosiPin 5
FEEDBACK
Visual Feedback : When information is entered on the reader’s
keypad, the red and/or green LEDs will flash, remain constant or
extinguish depending on the operation.
Confirmation Beep : When an operation is successfully entered,
the reader emits a rapid series of beep tones (“beep-beep-beep-
beep-beep”).
Rejection Beep : When the system reverts to a previous status or
an operation is incorrectly entered, the reader emits one long beep
tone (“beeeeeeeeeep”).
PROGRAMMING
Ensure that corresponding programming is completed in the
control panel or controller connected to the PosiPin. To program:
1. Press and hold the
[
CLEAR
] key for 4 seconds.
The reader emits a confirmation beep and the green LED illuminates.
2. Enter the [
INSTALLER CODE
] . Press the [
ENTER
] key.
(default:000000) Reader emits a confirmation beep and the green LED
flashes.
3. Enter the 3-digit [
SECTION
] . Press the [
ENTER
] key.
Reader emits a confirmation beep and the green LED stops flashing.
4. Enter the required [
DATA
] . Press the [
ENTER
] key.
The reader emits a confirmation beep and the green LED flashes.
5. To program another section, repeat steps 3 and 4. To exit
programming mode, press and hold the [
CLEAR
] key for 4 sec.
The reader emits a rejection beep and the green LED extinguishes.