Portwell ROBO-678, Руководство пользователя

Страница: 27 / 80

3
33
3----4 Installing the Single Board Computer
4 Installing the Single Board Computer 4 Installing the Single Board Computer
4 Installing the Single Board Computer
To install your ROBO-678 into standard chassis or proprietary environment,
you need to perform the following :
Step 1 : Check all jumpers setting on proper position
Step 2 : Install and configure CPU and memory module on right position
Step 3 : Place ROBO-678 into the dedicated position in your system
Step 4 : Attach cables to existing peripheral devices and secure it
WARNING
Please ensure that your SBC is properly inserted and fixed by mechanism.
Otherwise, the system might be unstable or do not work due to bad contact of
golden finger and ISA-bus slot. It is recommended to apply 4-pin 5-1/4” IDE
device power connectors from your power supply onto J22 to ensure a
sufficient current supply.
NOTE : Please refer to section 3-4-1 to 3-4-3 to install INF/VGA/LAN drivers.
3 33 3----4444----1 INF Chipset Component Driver 1 INF Chipset Component Driver 1 INF Chipset Component Driver 1 INF Chipset Component Driver
Intel 82815 GMCH chipset is a new chipset that a few old operating systems
might not be able to recognize. To overcome this compatibility issue, for
Windows Operating Systems such as Windows-95/98/98SE/2000, please install
INF Chipset Component driver before any of other Drivers are installed.
You can find very easily the INF chipset component driver in /INF directory of
ROBO-678 CD-title. Please execute “Setup.exe” to start installation.