System Installation
NANO-5050 User’s Manual
3-1
Chapter 3
System Installation
This chapter provides you with instructions to set up your system. The additional
information is enclosed to help you set up onboard PCI device and handle Watch
Dog Timer (WDT) and operation of GPIO in software programming.
3.1 Intel
®
Atom
TM
Processor D2550
Passively-cooled, soldered-down Dual-Core Intel ® Atom™ processor D2550 with
integrated graphics and integrated memory controller that’s suitable for fanless
system and low-watt design.
3.2 Main
Memory
NANO-5050 provide 1 x 204-pin SO-DIMM sockets which supports 800/1066 MHz
DDR3-SDRAM as main memory, Non-ECC (Error Checking and Correcting), non-
register functions. The maximum memory size can be up to 4GB capacity. Memory
clock and related settings can be detected by BIOS via SPD interface.
Watch out the contact and lock integrity of memory module with socket, it will
impact on the system reliability. Follow normal procedures to install memory
module into memory socket. Before locking, make sure that all modules have been
fully inserted into the card slots.
Note
: DDR3 1333 MHz and DDR3 1600 MHz memory will run at 1066 MHz
3.3
Installing Single Board Computer
To install your NANO-5050 into standard chassis or proprietary environment, please
perform the following:
Step 1 : Check all jumpers setting on proper position
Step 2 : Install memory module onto memory socket
Step 3 : Place NANO-5050 into the dedicated position in the system
Step 4 : Attach cables to existing peripheral devices and secure it
WARNING
Please ensure that SBC is properly inserted and fixed by mechanism.
Note:
Please refer to section 3.3.1 to 3.3.7 to install INF/VGA/LAN/Audio drivers.
