USER MANUAL
–
Portman P2 hexaline |
Safety information
P2 hexaline v2.0
5/16
Protection against electrical shock
•
Disconnect the fixture from AC power when not in use.
•
Disconnect the fixture from AC power before any operation.
•
Do not remove the rear cover. There are no user-serviceable parts inside.
•
Always ground the fixture electrically.
•
Use only the wires attached to the kit.
•
Use only a source of AC power that complies with local building and electrical
codes and has both overload and ground-fault protection.
•
Do not expose the fixture to rain or moisture.
•
Replace the lamp or fuse only as described.
Protection against burns and fire
•
Never operate when the fixture is damaged or some part is missing.
•
Do not touch surface when the fixture is in operation. The exterior of the fixture can
reach temperatures up to 100°C (212°F). Allow the fixture to cool approximately 30
minutes before any operation.
•
Replace the lamp when it becomes defective or worn out.
•
Never attempt to bypass the fuse. Always replace defective fuses with ones of the
specified type and rating.
•
Keep all combustible and flammable materials (for example fabric, wood, paper)
at a distance of at least 1 meter away from the fixture. Do not cover the fixture when
in operation and when it is hot.
•
Do not modify the fixture.
•
Do not operate the fixture if the ambient air temperature exceeds 45°C (113°F).
•
Do not operate the fixture after extreme change of surrounding environment
temperature. Allow the fixture to acclimate for at least an hour before operating.
Protection against falls
•
Use only attached base and addons to mount the fixture and always use attached
spigot and cotters
•
Never use more than one unit on base or on hanging clamp without additional
safety support
•
Never change position of hinges without additional safety support.
•
Ensure that the structure can hold at least 10 times the weight of all installed
devices..
•
Ensure that all fixtures are attached correctly to the structure, after having checked
that the housing is firmly closed and all screws are tightly fastened and use an
approved means of secondary attachment such as a safety cable.
•
Block access below the work area whenever installing or removing the fixture.
Protection against eyesight damage and epileptic seizure
•
Do not stare directly into the light. Never look at an exposed lamp while it is lit.
•
Provide advance notice that flash light is in use.
•
Avoid long cycles of rapid flashing light.
