1
REV: 2.3 (Standard, GT2000V3.1, GT2000-D2)
I. BRIEF INTRODUCTION
Personal Tracking System utilizes the GPS and GPRS functions in one unit. You can monitor the vehicle or
the people location and set the system remotely. In addition, the unit will send event report if any trigger
occurs.
The standard report sent by the unit includes the information: (1) unit’s ID, (2) status, (3) time, (4) GPS’s
latitude and longitude, (5) speed, (6) direction, (7) device’s status, (8) event number, and (9) report
configuration parameters.
The reporting mode can be categorized as ‘normal’ mode, and ‘power saving’ mode. In normal mode, the
GPS will always be activated while moving, and it can be shut off the GPS when stop (for power saving
purpose). To enable the maximum power saving, user can choose the “power saving” mode. In this mode, the
GPS will be activated only when there is a report to send while moving. The report parameters can be set
from the PC setup program. GT-2000 can be set to go in sleep mode (while not moving), the system will cut
the power of GPS module in order to save power. With build-in 3-D acceleration sensor, GT-2000 can select
related reporting modes with respect to it is moving or not.
The device has built-in 4 Geofences and one immediate Geofences (in circular shapes), it will send the report
to the server if the Geofence event is triggered.
The UNIT must be initialized by PC setup program in order to make communication with the remote server
/call center. There are three main sections that allow users to program the device, (1) User detail (Device ID,
server IP, and port, GPRS APN….) (2) Geo-fence (5 circular Geo-fence) (3) Report (Time, Distance, speed,
Low battery, wakeup …)
A unique help report: user can press the Button 3 for 2 seconds after the unit power on. The unit will send the
help report to server, power
LED flash 5 times at the same time.
When there is no GPRS service or the server close. The unit will send short message to the preset number.
The max. number of SMS message (monthly usage) and the monthly renew date can be set from the pc setup
program or the remote setup program. Only 1 SMS number can be set. The reports sent via the SMS will be
out again via GPRS after a valid GPRS connection is made.
GT-2000 can be configured by the PC setup program or the Over-the-Air (OTA) commands / or remote
program. The unit can communicate with the server via UDP or TCP protocol. The protocol can be selected
from the PC-setup program or remote server commands.
Flash memory for recording reports up to 900 reports. It can be read out from the PC setup program via serial
port.
On the left side, there are two buttons (+button and –button) used to change the ring volume. Push +button
for 2sec. to select
shock, ring or ring &shock together modes.
Recharge battery need three hours, after finish recharging, Power LED will change to green.
