Wire Nut
x 1
BB
Hardware Used
2. Screw the machine screws (AA) into the electrical box
until there is about 1/2 in. between the ceiling and the
underside of the screw head.
With power disconnected to the electrical box, remove the old fixture. If the old fixture is attached to
an electrical box having more than two (2) wire leads, use tape and markings to keep track of which
wires were attached to each other.
PREPARATION
ASSEMBLY INSTRUCTIONS
Before beginning assembly of product, make sure all parts are present. Compare parts with
package contents list and hardware contents list. If any part is missing or damaged, do not
attempt to assemble the product.
Estimated Assembly Time: 30 minutes
Tools required for assembly (not included): Phillips screwdriver, flathead screwdriver, safety
glasses, electrical tape, pliers, wire cutters, wire strippers, step ladder.
IMPORTANT:
The installation of this fixture will require you to provide a means of holding the
fixture in place while securing the fixture to the mounting surface. If no means of support for the
fixture can be provided, the installation will require 2 people to install – one to hold the fixture up,
while another person secures the fixture to the mounting surface.
Hardware Used
Machine
Screw
x 2
AA
1
3. For safety and proper operation, the fixture must be
properly grounded. A green or bare copper ground wire is
preassembled to the fixture (A). If the electrical box is
made of plastic and has a green or bare copper grounding
wire inside, the fixture ground wire must be spliced to the
green ground wire in the electrical box using one of the
wire nuts (BB). If the electrical box is metal and does not
have a visible ground wire, you can assume the metal
electrical box and metal conduit are already grounded. If
you are unsure if the electrical box is properly grounded, or
unfamiliar with the methods of properly grounding the
fixture, consult a qualified electrician.
Lowes.com/portfolio
3
AA
BB
BB
1/2 in.
2
AA
AA
AA
1. Using a flathead screwdriver and pliers (neither
included), remove the knockouts on the back of the
fixture (A) that correspond to the positions of the
mounting ears on the electrical box (not included).
A
1
