13
ADJUSTING THE CUTTER-ADJUSTING LEVER TENSION
Each time the blade is sharpened, the plane must be reset to “0” so that the
depth adjusting lever can accurately measure the depth of cut. If the cutter
adjusting lever is too tight or too loose, adjust it immediately to the proper
tension.
Re mo ve the f i v e han d l e- co v er
retaining screws on the right side
of the handle. Lift the handle cover
to reach the cutter adjusting lever
nut (A) Fig. 11. Tighten or loosen
this nut until the lever’s tension
is sufficient to hold it securely in
place. Attach the handle cover.
DISCONNECT THE TOOL FROM THE POWER SOURCE!
Do not pinch the wires!
Fig. 11
A
For assistance with your tool, visit our website at
www.porter-cable.com
for a
list of service centers, or call the Porter-Cable Customer Care Center at
(888) 848-
5175.
TROUBLESHOOTING
