Porter-Cable PCXB340SS, Инструкция по эксплуатации

Страница: 20 / 28

20
Fig. Q
RIP OR STRAIGHT LINE CUTTING (FIG. R)
To avoid injury from an accidental starting,
make sure the switch is in the OFF position
and the plug is not connected to the power
source outlet before moving, replacing the
blade or making adjustments.
Tools Needed (Not Included)
Q'TY DESCRIPTION
2 Small C-clamps
1 Ruler or measuring tape
1
12-inch (304.8 mm) straight
scrap of wood (Thickness to
match workpiece)
1. Raise the blade guard foot (1) by
loosening the blade guard foot lock
knob (2) on the left side of the upper arm.
Measure from the tip of the blade (3) to
the desired distance. Position the
straight edge (4) parallel to the blade at
that distance.
2. Clamp the straight edge (4) to the
table (5).
3. Recheck your measurements, using the
workpiece to be cut, and make sure the
scrap wood (6) is secure.
4. Position the workpiece against the blade
and place the blade guard foot (1) slightly
above the top surface of the workpiece.
5. Secure the blade guard foot in place by
tightening the blade guard foot lock knob.
WARNING
!
6. Remove the workpiece from the
blade before turning the scroll saw
ON. Set the desired speed by turning
the speed control knob clockwise or
counterclockwise.
In order to avoid uncontrollable lifting
of the workpiece and reduce blade
breakage, do not turn saw ON while
the workpiece is against the blade.
7. Position the workpiece against the
straight edge (4) prior to touching the
leading edge of the workpiece against the
blade (3).
8. Slowly feed the workpiece into the blade,
guiding the workpiece against the straight
edge and press the workpiece down
against the table while cutting.
Do not force the leading edge of the
workpiece into the blade. The blade
will deflect, reducing accuracy of cut
and may break.
9. When the cut is complete, move the
trailing edge of the workpiece beyond the
blade guard foot. Turn the scroll saw OFF.
NOTE: Use push stick when cutting a
narrow workpiece.
Fig. R
CAUTION
!
CAUTION
!
8
7
3
2
1
4
5
6
1
2
3
6
5
4