7
F - Installation instructions
INFORMATION FOR THE INSTALLER
The operations indicated below must be followed by qualified personnel, in conformity with the regulations
in force.
The supplier refuses all responsibility for damages to person or property, resulting from
the failure to comply with such provisions.
All units are 115Volt power and 60hz
The appliance is designed to be used near heat resistant pieces of furniture or kitchen cabinetry
only.
ELECTRICAL CONNECTIONS
Before carrying out electrical connection, be sure that the characteristics of the electrical system
meet the specifications located at the side of the drawer and the electrical system is provided with
effective ground in compliance with the regulations and provision of the law in your country.
The ground is required in all circumstances.
If you wish a direct connection to the line, it is necessary to use a single pole switch, with a
minimum opening between the contacts of 3 mm. suitable for the purpose and in conformity with
the rules in your country (the yellow/green ground cable should not be interrupted by the switch).
ATTENTION
Disregard of this precaution could cause the incorrect operation of the touch control system of the
cooktop and effect the product warranty provisions.
WARNING:
Installation must comply with Standards North America (within North America) wiring rules, as
well as your local electrical and building codes and regulations and any other applicable
requirements. Your appliance must be properly installed and grounded by a qualified and
licensed technician.
Incorrect installation of the appliance, resulting from the kitchen maker not following the detailed
installation specifications, can affect the appliance performance. Ovens incorrectly installed may
invalidate the warranty and we strongly recommend that the oven cavity and venting be prepared,
as described, in the following specifications. This is critical to appearance, oven performance and
safety.
Measurements
Please note that all dimensions provided are in millimeters (mm.) The sizes allow for only a small
degree of error so all cut-outs must be precise and square. To ensure the cabinet is well finished,
the cut edges must also be square and care taken to ensure the cut edges are free
Содержание 30 inch warming drawer
Страница 1: ......
Страница 8: ...8 16 615 240 730 600...
Страница 9: ...9 G Fixing drawer to the cabinet...
Страница 10: ...10 H Assembling oven drawer...