GETTING READY - INFLATING PORTAL Inflatable SUP
1.Unpack Your Inflatable SUP Set
2.Unlock Valve for Inflation
3.Pose
4.Secure air pressure
Choose a smooth and clean surface to unfold board. Roll out the inflatable SUP
board completely flat with the Non-Slip EVA Foam Deck side facing up.
Find the high pressure inflation valve near the bottom of the board. Twist the cap
counter clockwise to detach and access the center valve pin. Press the center pin
once to pop it up slightly. Now the valve is in "open" position for inflating . Be careful
of any sand or debris around the valve area when inflating and deflating, as small
particles could become airborne with the release of air.
Always keep the center pin in "close" position and screw the cap clockwise to block
air outflow when in use. This will prevent accidental air release and entrance of any
particles into the air chambers.
Connect pump and start inflating.
When PSI monitor reaches a desired level, please detach the hose from the valve.
Press the center valve pin down to "close" position and screw the cap clockwise to
secure are pressure.