Parking
191
Operating the garage door opener
The ignition must be switched on.
f
Press and hold the corresponding HomeLink
®
button on the overhead operating console
keypad.
The indicator light
A
lights up during signal
transmission.
Programming garage door opener:
Deleting and storing signals
The HomeLink
®
system is programmed on
the overhead operating console and in direct
proximity to the vehicle’s radiator grille.
Preconditions
In order to delete programmed signals and
store garage door opener signals,
– the ignition must be switched on,
– the turn signals must be off
and
– the engine must be off.
When using the garage door opener, the vehicle
must be within the range of the receiver.
Deleting programmed signals from the
buttons
This process clears all of the HomeLink
®
programming. It is not possible to individually
clear the programmed buttons.
Do not repeat this process if you want to assign
additional signals to the buttons.
f
Keep the two outer buttons
I
and
III
on the
overhead operating console keypad pressed
for approx. 20 seconds until the indicator
light
A
on button
II
starts to flash quickly.
f
Release the buttons.
The HomeLink
®
buttons are cleared and can be
reprogrammed.
Assigning garage door opener signal to key
with fixed code system
On the overhead operating console:
1.
Switch on ignition.
2.
The standard factory-set codes must be
deleted before programming for the
first
time
.
3.
Press and hold the desired button on the
overhead operating console keypad until the
indicator light
A
on button
II
starts to flash
slowly.
You now have 5 minutes to teach the button.
4.
Stand in front of the vehicle with the
original
remote control
of the system to be
programmed.
14_C7NF_21.book Seite 191 Mittwoch, 26. März 2014 12:15 12
