Porsche 1D6, Техническая информация

Страница: 9 / 12

Technical Information
Tequipment
27/07
ENU
6690
6
Figure 14
3 Route and connect electric wire harness.
3.1 Remove rubber sleeve from side panel and
guide all electric wire harness connectors
through the bore
⇒
Figure 14
-A, arrow-
and
into the passenger compartment.
Insert pre-fitted rubber sleeve into the bore on
the body.
3.2 Guide the wire harness into the vehicle as far
as necessary to ensure a sufficient distance
from the trailer hitch (clip on underside
⇒ Figure 14 -B, arrow- ) and from the
exhaust system
⇒
Figure 14
-B, X-
.
Figure 15
3.3 Trailer hitch connection diagram
A – 16-pin connector (black) → trailer
hitch control unit, connector A
C – 12-pin connector (blue) → trailer
hitch control unit, connector C
D – 10-pin connector (white) → switch
(not for USA)
E – 6-pin connector (green) → 4DR
connection point (trailer hitch prepa-
ration)
Figure 16
3.4 Route electric wire harness as follows:
Connector E (green)
→ connector strip for
existing wiring for trailer hitch
⇒
Figure 16
-E- ;
Route wire harness from inner side panel
behind the CD autochanger and amplifier to
the control unit installation position and fix in
place.
2007© Porsche Cars North America, Inc.
Tequipment
Aug 15, 2007
Page 9 of 12