Popp Ei600ZW, Быстрый запуск

Страница: 3 / 5

Node Information Frame
The Node Information Frame is the business card of a Z-Wave device. It contains information about
the device type and the technical capabilities. The inclusion and exclusion of the device is confirmed
by sending out a Node Information Frame. Beside this it may be needed for certain network operations
to send out a Node Information Frame.
A simple click on the 'Inclusion Button' sends a NIF.
Associations
Z-Wave devices control other Z-Wave devices. The relationship between one device controlling
another device is called
association . In order to control a different device, the controlling device needs
to maintain a list of devices that will receive controlling commands. These lists are called association
groups and they are always related to certain events (e.g. button pressed, sensor triggers, ...). In
case the event happens all devices stored in the respective association group will receive a common
wireless command.
Association Groups:
1 Lifeline (max. nodes in group: 10)
2 Alarm Reports (max. nodes in group: 10)
3 Switching Command when Alarm (max. nodes in group: 10)
Configuration Parameters
Z-Wave products are supposed to work out of the box after inclusion, however certain configuration
can adapt the function better to user needs or unlock further enhanced features.
IMPORTANT: Controllers may only allow configuring signed values. In order to set values in the range
128 … 255 the value sent in the application shall be the desired value minus 256. For example: to set
a parameter to 200 it may be needed to set a value of 200 minus 256 = minus 56. In case of a two
byte value the same logic applies: Values greater than 32768 may needed to be given as negative
values too.
Siren alarm sequence interval (Parameter Number 1, Parameter Size 1) The additional siren is
creating a different acoustic signal differentiate from the smoke alarm. This sound is partly on and
partly off. This parameter defines the total length of the interval in seconds.
Value Description
6 — 129 seconds (Default 10)
Siren alarm tone length (Parameter Number 2, Parameter Size 1)
The additional siren is creating a
different acoustic signal differentiate from the smoke alarm. This sound is partly on and partly off. This
parameter defines the total length of the sound versus silence within this interval. Please make sure
this value is always smaller (shorter time) than parameter 1 that defines the whole sequence.
Value Description
1 — 99 seconds (Default 8)