Note:
Numbers in
bold type
refer to call out numbers in illustration.
Page 6
EMHART TEKNOLOGIES
• 50 Shelton Technology Center, Shelton, CT 06484 • Tel. (877) EMHART1 • Fax: (800) 225-5614 •
www.emhart.com
PREPARATION FOR OPERATION
CAUTION:
Do not connect to air supply until all tool parts are properly installed.
Wear eye protection when operating this tool.
AIR SUPPLY REQUIREMENTS
1.
Use a dry, filtered air supply regulated to 75
- 85 psig (5 - 6 bar).
A minimum of 3.0 scfm
(85.0 liters / min.) is recommended. It is not nec-
essary and undesirable to lubricate the air sup-
ply. Excess oil, water or debris in the air supply
will necessitate more frequent tool service and
significantly reduce the operating efficiency of
the Mandrel Collection System. If the recom-
mended operating pressure is exceeded the
tool may not function because there is a built in
pressure limiter.
2. For optimum performance connect the tool air
line to an air supply line at least as large in
diameter as the air line supplied with the tool -
6.35mm (1/4 in.) minimum.
3. A lightweight, 6' (1.83 m) air line is supplied
attached to the tool to minimize operator
fatigue. Attaching an air line coupler at the tool
adds weight and changes the balance of the
tool.
PRT5400 / MCS5400
1. Select and attach the appropriate Nosepiece
(
12-A, 12-B, 12-C
) based on the rivet size /
mandrel diameter. The PRT5400 and MCS5400
Models arrive assembled with Nosepiece 12-C
suitable for 3/16" (4.8mm) diameter open end
rivets. To convert for smaller size rivets it is only
necessary to change the Nosepiece.
2. To set up the tool for 1/4" (6.4mm) diameter open end rivets attach Nosepiece
12-D
, install Jaws
3-B
, and
Jaw Pusher
22-B
and
remove
Mandrel Guide Tube
71
. Refer to
SERVICE PROCEDURES.
A wide variety
of Nosepieces are available from your POP distributor for special rivets and special applications or to
improve access problems.
3. Attach Deflector
47
or Collector
58
before operating tool.
PRT5400LS / MCS5400LS
1. Select and attach the appropriate Nosepiece (
12-A, 12-B, 12-C, 12-D
) based on the rivet size /
mandrel diameter. The PRT5400LS and MCS5400LS Models arrive assembled with Nosepiece
12-D
suit-
able for 1/4" (6.4mm) diameter open end rivets.
2. To convert for smaller size rivets attach the appropriate Nosepiece (
12-A, 12-B, 12-C
) and install Jaws
3-A
,
Jaw Pusher
22-A
and Mandrel Guide Tube
71
. Refer to
SERVICE PROCEDURES.
3. Attach Deflector
47
or Collector
58
before operating tool.
MODE
L54
00
