Page 11
PUSH PRO -0120843
UPPER CONTROLS
CONT.
1
From the lower controls, pull the emergency
stop button outward (refer to Figure 2).
2
Insert the key into the control selector switch
and turn the switch to the upper controls
position.
Note: The upper controls will not operate while
the control selector is in the lower position.
3
Enter the platform and secure the gate.
4
From the upper controls, turn the emergency
stop button clockwise to the on position (refer to
Figure 3).
5
The platform may be raised and lowered from
the upper controls.
PLATFORM
Use care when entering and exiting the platform to
avoid slipping and/or falling. Securely close the safety
gate when the platform is occupied.
COMPONENT TRAY
Batteries and hydraulic components are enclosed in
the component tray on the left side of the chassis.
DANGER:
THE AERIAL PLATFORM CAN TIP OVER IF
IT BECOMES UNSTABLE. DEATH OR SERIOUS INJURY
CAN RESULT FROM A TIP-OVER ACCIDENT. DO NOT
OPEN THE TRAY WHEN THE PLATFORM IS ELEVATED.
To open the tray, lift up on the tray latch and pull the
tray open.
RAISING AND LOWERING
Press and hold the interlock button on the left side of
the upper control box.
• To raise the platform, press and hold the platform raise
button until the desired height is reached.
• To lower the platform, press and hold the platform
lower button until the desired height is reached.
LOWERING INTERRUPT
When the platform is lowered to about 1.5m (5′)
lowering stops. The platform will not lower for five
seconds regardless of the joystick position.
Release the platform lower button to reset the lowering
function, then continue to lower the platform.
EMERGENCY LOWERING
Use the following procedure to operate the emergency
lowering system.
WARNING:
THE POTENTIAL FOR AN ACCIDENT
INCREASES WHEN SAFETY DEVICES DO NOT
FUNCTION PROPERLY. DEATH OR SERIOUS INJURY
CAN RESULT FROM SUCH ACCIDENTS. IMMEDIATELY
PUSH THE EMERGENCY STOP BUTTON INWARD TO
DISABLE THE CONTROL SYSTEM BEFORE USING THE
EMERGENCY LOWERING SYSTEM IN THE EVENT OF AN
EMERGENCY.
1
Immediately push the emergency stop button
inward to disable the control system in the event
of an emergency.
2
Make sure there is nothing in the way to
obstruct the platform when it lowers.
• Push downward on the lever to lower the
platform.
3
Make certain the lever/handle is fully released
and the emergency lowering valve is fully closed
before operating the aerial platform.
