poolstar PC-SKY075, Инструкция по установке и эксплуатации

Страница: 92 / 144

5
2. Attention
a. Please read the following instructions before installation, use and maintenance.
b. Installation must be done by professional staff only in accordance with this manual.
c. A leakage test must be performed after installation.
d. Except for the methods recommended by the manufacturer, do not use any methods to accelerate the
defrosting process or clean the frosted parts.
e. If a repair is required, please contact the nearest after-sales service center. The repair process must be strictly
in accordance with manual. All repair practice by non-professional is prohibited.
f. Set proper temperature in order to get comfortable water temperature to avoid overheating or overcooling.
g. Please don’t stack substances, which will block air flow near inlet or outlet area, otherwise the efficiency of
the heater will be reduced or even stopped.
h. Don’t use or stock combustible gas or liquid such as thinners, paint and fuel to avoid fire.
i. In order to optimize the heating effect, please install heat preservation insulation on pipes between swimming
pool and the heater, and please use a recommended cover on the swimming pool.
j. Connecting pipes of the swimming pool and the heater should be ≤10m.
3. Safety
a. Please keep the main power supply switch far away from the children.
b. When a power cut happens during operating, and later the power is restored, the heater will start up.
c. Please switch off the main power supply in lightening and storm weather to prevent from machine damage
that caused by lightning.
d. Installation and any repairing should be conducted in the area with good ventilation. The ignition source is
prohibited during the operation.
e. Safety inspection must be carried before the maintenance or repair for heat pumps with R32 gas in order to
minimize the risk.
f. If R32 gas leaks during the installation process, all operations must be stopped immediately and call the
service center.