Poolspa Klio asymmetric 140x80, Инструкция по эксплуатации

Страница: 7 / 16

7
15.2. SX2 SYSTEM - water and air system
• Water massage
- 4 fi xed back nozzles,
- 2 fi xed foot nozzles (excluding Klio Asymmetric 140 x 80),
- 4 fl at side nozzles with the option to direct water stream,
- independent control of back/side/foot massage intensity through aeration,
- water level sensor that prevents the pump from running dry,
- drain for removing water from the water massage system after bath.
• Water massage intensity control knobs
- bathtub top includes control knobs for adjusting air fl ow that adds aeration to water massage.
The control knobs direct air to side nozzles, back nozzles and foot nozzles.
• Air massage:
- system of air ducts in the bathtub,
- drain for removing water from the air massage system after bath,
- automatic hot air drying of the air system after bath.
• Chromotherapy
- multi-color LED spotlight.
SX2 hydro-massage system control
Proper activation or deactivation of features is always con fi rmed with a beep.
System activation:
Touch the symbol once to activate the hydro-massage system (all icons on the control panel
as well as the LED light with automatic color changer will be switched on).
Touch the symbol again to deactivate the entire system.
Water massage:
The bathtub is equipped with a water level sensor to prevent the water massage pump from running
dry. If the water level is below the required level, the pump will not start.
Touch the symbol once to activate the water massage pump.
Touch the symbol again to deactivate this feature.
The massage switches off automatically after 30 minutes. The system will then wait until you switch it back on or empty
the bathtub.
Air massage:
Touch the symbol once to activate the air massage pump. Touch the symbol again to deactivate this feature.
The massage switches off automatically after 30 minutes. The system will then wait until you switch it back on or empty
the bathtub.
Blowing through air ducts:
The air nozzles are automatically blown through and dried 30 minutes after draining water from the bathtub (for 5
minutes), even if none of the features was activated.
If the bathtub was fi lled with a small amount of water, the water level sensor will not detect it. That is why, once
you empty the bathtub, activate the blower for ca. 1 minute manually to blow through air nozzles and remove
remaining water.