CONNECTING THE POOL PUMP
●
Raise the clear Control Panel Cover on the front of the Power Pack and loosen the
two retaining screws in the bottom right hand corner and remove the Cable Entry
Cover by pulling downwards.
●
Plug the pool pump into the pump socket at the bottom of the unit.
(see Note below about the use of large or 3 phase pumps).
●
Refit the Cable Entry Cover making sure all cables pass through the tunnel behind
it to ensure they do not interfere with the proper closing of the Control Panel Cover.
●
Tighten retaining screws.
Off-Peak Installations
This unit is not suitable for connection to an off-peak tariff supply.
Warning: The Warranty will be void if the Power Pack is installed or operated .....
a)
on, or less than 1 metre from the ground.
b)
in a position where flooding from ground water could occur.
c)
where the airflow is obstructed, i.e. within an unvented auxiliary enclosure.
d)
with the weatherproof Control Panel Cover permanently open or removed if
installed outdoors
.
e)
with a load (pump) connected to the 240 volt pump outlet socket greater than
1.5kw (continuous).
e)
from an electrical supply socket which is not rated to supply 10 amps at 240 volts
50Hz and is not adequately protected by the correct size fuse or circuit breakers.
4
PLR183 _Endchlor MAN-txt 17/7/06 12:20 PM Page 4
