(1)
6
WARNING NOTE:
Before attaching the 3-Way
Bypass Valve, make sure you note the
RIGHT
FROM FILTER marking on the valve. (See photo
on far right.) FAILURE TO CONNECT THE 3-WAY
BYPASS VALVE IN THE RIGHT WAY WILL RESULT
IN IMPROPER WATER FLOW AND POTENTIAL
DAMAGE TO YOUR ENTIRE SYSTEM
.
• Detach the end of the hose that connects to
your pool where the water is returned.
• With this unattached end, loosen and place a
hose clamp over the end of the hose & insert
over the adapter on the noted
RIGHT
FROM
FILTER side of the 3-Way Bypass Valve (1).
Make sure the hose is pushed all the way to the
end of the adaptor. Tighten the hose clamp.
WARNING NOTE:
The 3-Way Bypass Valve must
be installed between the pump/filter and solar
heater otherwise DAMAGE TO THE SOLAR HEATER
WILL OCCUR.
• With a new hose, place a hose clamp over the end
of hose and insert over the
adapter on the noted
“TO SOLAR HEATER” side (bottom opening) of the
3-Way Bypass Valve (2).
Make sure the hose is pushed all the way to the
end of the adaptor. Tighten the hose clamp.
• Prepare the unattached hose end coming from
the
noted bottom opening TO SOLAR HEATER
side of the 3-Way Bypass Valve & follow Diagram 3
for order of parts and connection to each other.
DIAGRAM 3
INCOMING HOSE CONNECTION COMPONENTS
Hose end (A) + clamp (D) + hose reducer (E) + water controller (F) + side hose connector (B) + O-ring (C)
(Use your flat head screwdriver to loosen and tighten the hose clamps)
A
D
E
F
B
C
From
Filter
To Solar Heater
Bypass to Pool
(1)
(2)
RIGHT
