Pony Espresso T 134, Инструкция по эксплуатации, Страница: 5 / 25

DAILY MAINTENANCE
Attention: Do not use pressure sprays or hoses to clean the machine. Likewise, the machine must never be immersed in a liquid.
On each end of use, the different parts must be cleaned as follows:
•
Coffee infusion assembly (Fig. 2)
−
Infuse 2 or 3 cycles but without coffee to clean the whole unit.
−
Remove the filter-holder (C), the filter assembly (B) and the spout (E) (Fig. 2).
−
Clean separately each part.
−
Reassemble all parts carefully.
•
Steam tube
After each use, clean the steam tube with a wet rag and turn the steam button for a short moment to eliminate the small amount
of milk inside the tube.
•
Waste drawer and grid
Both must be carrefully rinsed to remove all traces of coffee oils. The drawer can be rinsed with hot water (60°C maximum)
with household dishwash liquid. The grid can be washed in a dishwasher.
•
Body work
Before cleaning body work, Put the switch (F) on position "0".
Use only a soft cloth and non-abrasive cleaning liquid for all metal and plastic parts.
•
Water tank
The tank must be cleaned daily, using only food-grade products.
Wipe the silicone tubes with a soft cloth.
Water in the tank must be changed daily. Preferably use a water of low mineral salt content.
PULY CLEANER BABY
In order to increase the use long life, to maintain the best performances of your machine, and to avoid an
untimely complete scaling, please start a cycle of scaling at least each 500 coffee cups.
•
The machine switched on, empty the tank, then melt the PULY CLEANER BABY small bag with 1,5 liter
of cold water (well mix).
•
Place the tank in position in the machine.
•
Open the filter-holder cup, place a container under the unit, and turn the button on coffee position letting out
about two or three hot water cups.
•
Wait 15 minutes keeping the machine hot.
•
Operate again the pump at regular intervals of about 1 minute until the level control light is lighting, press
on the tank in order to suppress the low level safety, and operate the pump until the tank is empty.
•
When this operation is finished, rinse carefully the tank, put 3 liters of clean water, and operate the pump
intermittently until the water safety is starting.
•
Empty again the tank and fill it with clean water, the machine is ready.