TD4000A Hardware User Manual
Set current and time, and output time will be shown real-timely after run. Iout
and Uout will be shown which are the real output current and voltage.
The set current will be put out by pushing RUN button and it stops output when
getting to the set time. If there is over load, the overheat lamp will give a signal
and the system will stop output. There is a period of cooling time which is
connected with the present current output time and maximum time is 120s.
After cooling, it can go to next output. The equipment needs 30s cooling time
after power on, and it counts from current output until that the binary receives
signal flip recording actions time.
Notes:
The cooling time means the minimum cooling time for the equipment normal
working. It is advisable that the real cooling time is 2-3 times longer than display
cooling time between two current outputs which can improve stability and precision
of the device. The following is the same.
15
