PondXpert PondMaster PXVACMASTER-NS, Инструкция по эксплуатации

Страница: 7 / 12

Thank you for purchasing this pond vacuum cleaner, a high-quality product based on the
newest state-of-the-art technology. The vacuum cleaner is suitable for use in garden ponds,
but can also be used to empty large amounts of water quickly – eg, hot-tubs.
Please read the following instructions carefully and thoroughly.
Failure to comply with
these requirements could cause serious injury and may result in product damage or
failure.
Important!
1. Safety Warnings

The power supply must correspond to the product specification. If necessary, ask for
information from your local electricity supplier regarding connection regulations. Do not
connect the device if these do not meet the mentioned regulations (the voltage
specification must match the operating voltage).

The device must be connected to a 30mA RCD (Residual Current Device) for prevent
the possibility of electric shock and to comply with Europe safety standards. Further
information is available from your local electricity specialist.

The device must be fully assembled before use.

Packing parts may be dangerous (eg. plastic bags). Therefore, store away from children,
domestic animals and anyone incapable of understanding the dangers. This device is
not a toy.

When cleaning a pond, the device should be positioned with a clearance of 2 meters
from the water’s edge.

Never leave the device unattended.

Never carry or pull the device by the power cable.

Do not pull the device behind you by the hose during operation.

Do not cut off the plug and do not shorten the cable. Your guarantee becomes invalid if
this is not observed.

When using outdoors, ensure that the plug and socket are completely dry.

Never touch the plug with wet hands.

When the device is switched on, do not hold the suction nozzle close to sensitive body
parts like eyes, ears or mouth.

Before emptying the vessel, switch off the device and remove the plug from the RCD.

Always switch off the vacuum cleaner and pull out the plug before cleaning the device.
Do not immerse the motor head (3) into water for cleaning purposes or clean with a
water jet.

This device is suitable for sucking water with a maximum temperature of 35 degrees.

Replacement of the electric cable is not possible. The device must not be operated in
the case of a defective electric cable or housing.