background image

Please consult your retailer for quality original PondMAX replacement parts.

Visit www.pondmax.com.au for your nearest stockists. 

E.&O.E.

IMPORTANT SAFEGUARDS

To guard against injury, basic safety precautions should be 

observed including, but not limited to the following;
•  The pump should only be used in clean water
•  Do not use the pump in any solvent or gasoline that is 

flammable.

•  Do not operate the pump without water at any time, 

permanent damage may occur.

•  Do not operate the pump if the pump or any of the 

components of the pump such as the power cable have 

been damaged.

•  The drip loop method should be used to prevent water 

from traveling down the cord onto the plug or power 

point. If the plug does get wet, do not unplug the cord. 

Disconnect the circuit breaker that supplies power to 

the power point. Then unplug and examine the plug 

and power point for presence of water. If the power 

point has become wet, you should consult an electrician 

before using the power point again.

•  Warning: Always use a properly grounded power 

supply that is connected to an RCD with a rated 

residual operating current not exceeding 30mA as per 

AS/NZS 3350.2.41:1997.

•  Always unplug the pump from the power supply when 

not in use or before performing any maintenance on the 

pump or in the pond. Never pull the cord to disconnect 

the plug from the power supply. Grasp the plug and pull 

to disconnect.

•  Do not install or store the pump where it will be 

exposed to extreme hot or cold temperatures.

•  Do not cut the cord as this will result in voiding your 

warranty.

•  Keep out of reach of children or pets. This appliance 

should not be used by children or infirm persons 

without supervision.

•  Care should be taken to arrange the power cord so that 

it cannot be accidentally tripped over or pulled.

•  Do not attempt to repair the pump yourself. Return to 

an authorised service centre or place of purchase if a 

fault occurs.

•  Do not use in water above 35°C.

LIMITED WARRANTY
IMPORTANT: IF USED IN MARINE OR SALTWATER, DUE 

TO THE HARSH CONDITIONS THE WARRANTY IS VOID.

•  This product comes with a warranty against defects and 

motor failure (Warranty). The benefits provided in this 

Warranty are in addition to other rights and remedies 

available to you under the Australia Consumer Law. The 

Warranty is provided to the original purchaser of the 

product on the following terms:

•  The Warranty is given by Chemkay Pty Ltd trading as 

Aquatec Equipment: PO Box 2087, 

Seville Grove, WA 6112. Tel 1300 552 202 or email sales@

aquatecequipment.com.

•  To make a claim under the Warranty you must return 

the faulty product to the place of purchase with a valid 

receipt or proof of purchase.

•  A Warranty claim must be made within 3 years of the 

date of purchase.

•  If your claim complies with the above terms and the 

product is not an exhaustible Item and no voiding 

events have occurred, we will (at our sole discretion): 

  -  repair the product, if possible; or 

  -  provide a replacement product; or 

  -  if a replacement product is not available, provide a 

refund for the purchase price paid.

•  You will bear the cost associated with claiming under 

the Warranty such as the cost of transportation and 

delivery of the product to and from the place of 

purchase.

•  The product contains a complete Impellor Set, O Ring 

& UV Globe. These items are exhaustible (Exhaustible 

Items) and are not covered under the Warranty.

•  The Warranty will be void if any of the following events 

occur, as determined by us, at our sole discretion 

(Voiding Events): 

  -  any tampering/removal of warranty/identification 

labels or electrical components is evident; 

 

-   the defect has arisen due to: an accident, incorrect or 

inadequate installation, misuse or abuse 

    of the product (including improper maintenance 

and service), excessive wear and tear, not 

    following manufacturer’s guidelines/ instructions, 

or the product has been used in a manner 

    contrary to the purpose or suitability of the 

product; 

  -  the product has been modified without our 

authority; 

  -  the defect is caused by power surges/spikes 

brownouts.

•  Loss of livestock, damage to property or personal injury 

caused by the improper use or abuse of the product 

will not be covered and the manufacturer excludes all 

liability for such events, to the extent permitted by law.

•  In addition to the Warranty set out above, our goods 

come with guarantees that cannot be excluded under 

the Australian Consumer Law. You are entitled to 

a replacement or refund for a major failure and for 

compensation for any other reasonably foreseeable 

loss or damage. You are also entitled to have the 

goods repaired or replaced if the goods fail to be of 

acceptable quality and the failure does not amount to a 

major failure.

P O N D M A X . C O M . A U

PMAX PMAX PS200_PS600_PS1700_PS3500 Solar Instructions.indd   8

PMAX PMAX PS200_PS600_PS1700_PS3500 Solar Instructions.indd   8

22/6/20   1:11 pm

22/6/20   1:11 pm

Содержание PS200









Отзывы: