P O N D M A X . C O M . A U
P O N D M A X . C O M . A U
SOLAR PUMP
INSTRUCTIONS
ASSEMBLY & INSTALLATION
(CHECK MODEL FOR CORRECT PARTS)
• Unpack all components carefully.
• For the application of pumping a water feature, screw the tubing connector onto the pump outlet and
then connect the tubing from the pump outlet to the water feature inlet.
• For the application of creating a spraying up fountain, please follow the steps below:
• Mount the nozzle accessories on the top of the pump outlet. Totally, there are three types of nozzle
tip provided, including an apple fountain tip, a volcano fountain tip and a special foam effective
nozzle tip which can trap a large amount of air into the water to significantly boost the oxygen levels
in water.
• Place the pump in your pond or water feature.
• It is better to keep the pump off the pond floor to avoid sucking in the pond waste into the pump,
which would easily develop into pump blockage.
• To properly install the volcano fountain head, the extension tubes should be used to lift the fountain
head above the water surface, but as low as possible so that the entire length of the water spray can
be exposed to maximize the visual effect, as shown in Fig 1.
• To properly install the apple fountain head, the fountain head should be lifted to a position above the
water surface far enough to allow forming an ideal apple shaped fountain. To adjust the size of the
apple fountain sphere, vary the water discharge gap by pressing or lifting the nozzle top piece, as
shown in Fig 2. The larger the discharge gap, the smaller the apple sphere.
• To properly install the foam effective fountain head, please make sure the nozzle top piece is left out
of water so that air can be sucked in from the gap underneath it, as shown in Fig 3.
• If all the 4pcs of extension tubes are used and the fountain head still can not reach the right position,
please uplift the pump body somehow.
• Connect the pump cable to the solar panel, and tighten the protection collor.
• Install the solar panel in garden lawn or soft ground by jabbing the spike into the ground. Adjust the
orientation of the panel to face it towards the sun.
• Make sure to keep the pump fully submerged in water while the pump is in operation.
• The solar pump is now ready to operate
Fig 1.
Fig 2.
Fig 3.
PMAX PMAX PS200_PS600_PS1700_PS3500 Solar Instructions.indd 5
PMAX PMAX PS200_PS600_PS1700_PS3500 Solar Instructions.indd 5
22/6/20 1:11 pm
22/6/20 1:11 pm
