PondMAX 24PL680, Инструкция по эксплуатации

Страница: 13 / 16

WAT E R G A R D E N I N G T O T H E M A X WAT E R G A R D E N I N G T O T H E M A X
COLOR CHANGING LED
LIGHTING SYSTEM
TROUBLESHOOTING
Problem Reason Solution
LIGHT NOT WORKING
No Power
Check that the ransformer plug is connected and
power point is working.
Bad Transformer
Replace the ransformer or the fuse within the
ransformer (if applicable). Check that there is
not more than the recommended amount of
lights running off the ransformer.
Short Circuit/Bad Connection
Inspect and test every light, lamp and connection
individually on a good ransformer until it is
determined where the short is at. Replace parts to
correct the short.
Damaged Cable
Inspect the entire length of the lighting system
cable and look for cuts or damage resulting in
exposed copper wire. Replace cable or complete
fixture where the damage is.
Defective Lamp
Inspect the lamp socket is not damaged and make
sure that the inside of fixture is free of moisture.
Replace the lamp.
Bad Controller
If Possible test the controller with a good ransformer
an amp meter. Do not connect a light during
this test. The controller should only read 0.05 amps.
Replace the controller. Check that there is not more
than the recommended amount of lights on one
controller .
Remote Not Working
Change the battery in the emote. air the emote
to the controller by unplugging the power. Then
hold your finger on the power button on the emote
and plug the system in while doing so. Continue to
hold the button until the lights blink, then test again.
Replace emote if necessary.
LIGHT WORKING
INTERMITTINGLY
Damaged Cable
Inspect the entire length of the lighting system
cable and look for cuts or damage resulting in
exposed copper wire. Replace cable or complete
fixture where the damage is.
Short Circuit/Bad Connection
Inspect the entire length of the lighting system
cable and look for cuts or damage resulting in
exposed copper wire. Replace cable or complete
fixture where the damage is.
Defective Lamp
Inspect the lamp socket is not damaged and make
sure that the inside of fixture is free of moisture.
Replace the lamp.
Bad Transformer
Replace the ransformer. Check that there is
not more than the recommended amount of
lights running off the ransformer.
Lights Not Coordinated With Remote
Test by removing the first light in the system.
If problem is fixed replace that one light. If not
fixed then replace the controller and emote set.
Check to make sure there is not more than the
recommended lights on one controller.
Remote Not Working
Change the battery in the emote. Pair the emote
to the controller by unplugging the power. Then
hold your finger on the power button on the emote
and plug the system in while doing so. Continue to
hold the button until the lights blink, then test again.
Replace emote if necessary.
12